Info: assembly instructions for the installation of seat covers!

Recently updated on January 27, 2022 at 10:43 am

After we are already in the course of our Tuning Wikipedia on the topic covers have dealt with, we now want one general assembly instructions provide. Of course, we are aware that it is difficult to generalize these installation instructions, because given the countless suppliers of seat covers and the equally countless types of vehicles, this is simply not possible. Nevertheless, we hope that the instructions can be at least roughly helpful, which of course also applies to the embedded video.

Assembly instructions - protective covers

Required utensils: One is helpful scissors (alternatively a craft knife) and also a screwdriver (Slot) can be useful. Of course, you should be careful with both utensils! In some cases, when assembling the seat covers in the car, you cannot get between the seat and the backrest. In this case it is recommended to use the felt under the seat to solve.

Assembly of the seat

1. The cover must be placed on the desired seat. It must be noted that this ungefähr the way the original cover fits.
2. The back of the cover must be between the seat and the backrest be pushed.
3. The front pieces and the side pieces should now be over the seat be put on.
4. Use the screwdriver to attach the hose straps laterally between the backrest and the seat be pulled through. The hose straps are then pulled together at the back.
   
5. The side panels must now between the panel and under the seat cushion be hidden. The screwdriver can be used for this.
6. The hose straps are at the back drawn togetherso that the cover contracts and sits tightly.
7. Any existing hooks will be on the rubber bands appropriate.
8. It must be ensured that the seat cover sitting properly. If this is not the case, the reference should still be made accordingly be aligneduntil it is properly seated.
9. Then the cover is pulled tight on the back fabric and fastened with the hooks under the seat. It must be noted that the hooks in a stable place under the seat .

Assembling the backrest

1. The headrest must be off the seat removed and the cover is then placed over the backrest.
2. For vehicles with a folding table:
   - With a folding table, the screws, which are usually somewhere under the folding table are to be resolved. After the cover has been put over the backrest, it must be at the height of the screws a small cut cut into the fabric. Then the folding table is attached again.
3. The piece of felt will between the backrest and the seat pushed and pulled tight. The felt surface can now be placed against the backrest.
   NOTICE: Do not attach the felt surface to the recess for the airbag.
   
4. The counterpart of the Velcro fastener must be removed and on the felt surface .
5. It must be ensured that the reference sitting properly. If it doesn't, it should be properly aligned.
6. With the scissors will a small cross cut into the fabric. These holes must be level with the holes for the headrests. Now the fabric has to be put over it and hidden under the plastic cover.
7. Any supplied covers for the headrest are easy pulled over this.
8. Done!

Of course, that wasn't the end of it!

tuningblog has countless other articles on the subject of car and auto tuning in stock. Do you want to see them all? Just click HERE and look around. In part, we would like to provide you with news but also off the tuning. In our category Tips, products, information & Co We have reviews of car or accessories manufacturers, new ones Tuning Wiki Terms or one or the other Leak veröffentlicht. Following an excerpt of the last articles:

"Tuningblog.eu" - we keep you up to date on the subject of car tuning and car styling with our tuning magazine and we present you the latest tuned vehicles from all over the world every day. It's best to subscribe to ours Feed and will automatically be informed as soon as there is something new about this post, and of course also to all other contributions.